Ducati Diavel
Free Service and Repair manuals

Ducati Diavel Service Manual: Abs system deactivation

Carry out the procedure described in section sec. 6 - 7, Abs disabling function.

Warning

If the vehicle front wheel remains off the ground for a prolonged period while the vehicle is in motion, the speed difference detected between the two wheels causes an abs fault (warning light activated) and makes it impossible for the control unit to establish a reference speed.

Abs system operating information
The response of the system is based on the analysis of the speed signals for front and rear wheels; the system is automatically deactivated if either of these signals is missing. Note In the even ...

System components
Screw Abs front speed sensor Sealing washer Hose grommet Abs rear speed sensor Abs control unit Front pump - control unit pipe Control unit - front callipers pipe Rear pump - co ...

Other materials:

Hands free key (hf) not recognised
The activation of this (amber yellow) "warning" indicates that the hands free system does not detect the active key (1, fig. 62) Near the vehicle. Note In this case, ducati recommends checking that the active key (1, fig. 62) Is near the vehicle (and has not been lost) and that it f ...

Removal of the lubrication system
Disconnect the sensor (12) of the main wiring. Open the pipe grommet (11). Undo the screw (8) and slide out the plate (9). Slide the tubes (7) out of the half-casing having care not to damage the tubes o-rings (a) that guarantee the coupling sealing. Undo and remove the sc ...

Engine temperature sensor
Introduction The engine control system on the diavel uses a sensor that measures the temperature of the coolant (engine temperature). This sensor has a resistance of ntc type (negative temperature coefficient), that reduces its own value when the temperature increases. The engine temperature ...

2026 | www.dudiavel.com |