Ducati Diavel
Free Service and Repair manuals

Ducati Diavel Service Manual: Airbox - throttle body

Ducati Diavel Service Manual / Fuel/exhaust system / Airbox - throttle body

Airbox - throttle body


  1. Airbox
  2. O-ring
  3. Injector
  4. Throttle body assembly
  5. Screw
  6. Clamp
  7. Intake manifold
  8. Screw
  9. Pressure sensor
  10. Screw
  11. Clamp
  12. Hose
  13. Sealing washer
  14. Intake manifold
  15. Sealing washer
  16. Screw
  17. Screw
  18. Spacer
  19. Bracket
  20. Rubber pad
  21. Clamp
  22. Hose
  23. Clamp
  24. Union
  25. Washer
  26. Hose
  27. Cable grommet
  28. Spare parts catalogue
  29. Diavel abs throttle body
  30. Diavel abs Air intake - oil breather
  31. Diavel abs fuel system
  32. Diavel carbon abs throttle body
  33. Diavel carbon abs air intake - oil breather
  34. Diavel carbon abs fuel system

Important

Bold reference numbers in this section identify parts not shown in the figures alongside the text, but which can be found in the exploded view diagram.

Refitting the fuel tank
If the fuel tank has been disassembled into its component parts, reposition all the parts as shown in the exploded view. In particular: tighten the screws (13) to a torque of 5 nm +/-10% (sect. ...

Removal the airbox and throttle body
Loosen the screws (a) and remove the plate (b) that fixes the main wiring to the airbox. Undo the screws (17) and remove the air pressure sensors (9) with the support (19). Release t ...

Other materials:

Reassembly of structural components and the frame
Check for the nuts with clips (8). Apply recommended grease on the threads of the adjusters (4) and the ring nuts (5) having care not to have grease on the surface (c) of the adjusters. Tighten the adjusters on the ring nut side opposite to that featuring flats until bringing the surfac ...

Refitting the hands free
Reassembly is a reversal of the removal procedure: in particular apply prescribed threadlocker to screws (2) and tighten them to a torque of 20 nm +/- 10% (sect. 3 - 3, Frame torque settings). If the hands free button has been previously removed, when refitting it insert the spring (6) on pi ...

Checking the engine timing
Set the engine to the configuration described for the "checking and adjusting the valve clearances", previously indicated. Install tool 88765.1188 (G) in the spark plug bore to determine the piston tdc, the gauges (h) on the tool 88765.1518 And the timing check tool (degree wheel (l) 887 ...

2026 | www.dudiavel.com |