Ducati Diavel
Free Service and Repair manuals

Ducati Diavel Owners Manual: Backlighting setting function for the instrument panel on Handlebar - dashboard 2

Ducati Diavel Owners Manual / Instrument panel (dashboard) / Backlighting setting function for the instrument panel on Handlebar - dashboard 2

This function allows backlighting setting of the instrument panel on handlebar.

To access the function it is necessary to view the "setting" menu page 48, using button (1, fig. 14) ?"
" or (2, fig. 14) ?" " select the "back light" function
and press the reset button (12, fig. 12) To go to next page.

Use button (1, fig. 14) ?" " or (2,
fig. 14) ?"" to select the
"dashboard 2" function and confirm by pressing the reset button (12, fig. 12).

Once you enter the "dashboard 2" function, setting is highlighted on the display (max, middle or min in green); use button (1, fig. 14) ?"
" or (2, fig. 14) ?" " to shift the
arrow on the left onto the new setting and confirm by pressing the reset button (12, fig. 12).

To exit the setting function, press the reset button (12, fig.

12) Where "exit" is highlighted.

Select "max" setting and the background of the instrument panel on handlebar permanently sets backlighting to maximum power to improve readout view - recommended with bright exterior lighting.

Select "middle" setting and the background of the instrument panel on handlebar permanently sets reduced backlighting to 30% of its maximum power for dimmed visibility - recommended with poor exterior lighting.

Select "min" setting and the background of the instrument panel on handlebar permanently sets reduced backlighting to 50% of its maximum power for dimmed visibility - recommended with very poor exterior lighting and/or dark.

Backlighting setting function for the instrument panel on handlebar - dashboard 2


Background setting function for the instrument panel on tank - dashboard 1
This function allows setting the "background" of the instrument panel on tank. To access the function it is necessary to view the "setting" menu page 48, using button (1, fig ...

Digital rpm indication function
This function displays the number of rpms for improved accuracy when setting idle rpm. To access the function it is necessary to view the "setting" menu page 48, using button (1, fig. ...

Other materials:

Abs diagnosis
Note The on-screen icons used during this procedure are explained in a table at the end of this section. If the abs system is not working correctly, system diagnosis is possible through the dds diagnosis instrument. Turn on the dds diagnosis instrument (1) referring to the paragraph "tester ...

Refitting the external components
Fit the cap (39) on spring (38) until it engages. Mount ball (40), spring (38) with cap (39), washer (37) and screw (36) on the chain side half-casing by starting the screw into hole (f). Note The spring (38), with cap (39), must be oriented as shown. Tighten the screw fully home to a torqu ...

Checking protection and safety device components
Checking the side stand switch Remove the switch (1) from the side stand undoing screw (2) and disconnect the main wiring connector from the switch (see paragraph "routing of wiring on frame", sect. 6 - 1). Use an analogue or digital multimeter (sect. 6 - 11, Using a multimeter to check the ...

2022 | www.dudiavel.com |