Ducati Diavel Service Manual: Battery charging system

Routing of wiring on frame

The routing of the wiring has been optimised to ensure the minimum obstruction. Each section is designed to prevent interference with parts that might damage wires or cause operating failures w ...

Checking the battery charging system

To check the current flow of the recharging circuit, use the "dds" diagnosis instrument, which is equipped with an inductive clamp-type amperemeter: refer to chapter "testing the battery charging ...

Other materials:

Passive key
Introduction The passive key (1) is used when the active key is not working correctly or is not available. The passive key works as a transponder, and must therefore be placed physically onto the antenna to work. The mechanical part (2) of the key is used to open the seat or the tank plug ...

Key-on/key-off using the red key on the handlebar with the active key
A key-on can be performed by pressing the red key (6) on the handlebar in the hands free on/off position and in the presence of the active key (3, fig. 77). Note The active key (3, fig. 77) Has a range of approx. 1.5 M, therefore it must be located within this range. Key-off can be performed ...

Gearchange mechanism
Return spring Washer Special screw Gear pawl assembly Interlock plunger holder Sealing washer Detent ball spring Ball Circlip Selector claw return spring Shim washer Ring Nut Selector drum control fork Gearchange lever pin Shaft with gearchange lever arm Gearch ...