Ducati Diavel
Free Service and Repair manuals

Ducati Diavel Service Manual: Camshafts

Camshafts


  1. Head
  2. Stud bolt
  3. Special screw
  4. Sealing washer
  5. Horizontal cylinder head cover
  6. Vertical cylinder head cover
  7. Special screw
  8. O-ring
  9. Head gasket
  10. Screw
  11. Pin
  12. Union
  13. Clamp
  14. Horizontal cylinder exhaust camshaft
  15. Horizontal cylinder intake camshaft
  16. Plug
  17. Sealing ring
  18. Vertical cylinder exhaust camshaft
  19. Key
  20. Vertical cylinder intake camshaft
  21. Screw
  22. Timing side support
  23. Opposite side support
  24. Sealing washer
  25. Intake manifold
  26. Screw
  27. Sealing washer
  28. sealing washer

Spare parts catalogue

Diavel abs cylinder head: timing system

Diavel abs vertical cylinder head

Diavel abs horizontal cylinder head

Diavel abs throttle body

Diavel carbon abs cylinder head: timing system

Diavel carbon abs vertical cylinder head

Diavel carbon abs horizontal cylinder head

Diavel carbon abs throttle body

Important

Bold reference numbers in this section identify parts not shown in the figures alongside the text, but which can be found in the exploded view diagram.

Refitting the timing covers
Locate vertical cylinder external cover (25), horizontal cylinder external cover (3) and central external cover (1) by starting the screws (4). Apply the recommended threadlocker to the screws ( ...

Removal of the camshafts
Unscrew and remove the screws (7) and the o-rings (8) from the cylinder head covers. Remove the cylinder head cover (6). Remove the gaskets (4) and (9). Repeat the same procedure fo ...

Other materials:

Refitting the camshafts
If the stud bolts (2) were removed, apply the recommended threadlocker to the short end of the stud bolts (2), i.E. The end that is to be screwed into the cylinder head. Tighten the stud bolts (2) to a torque of 10 nm (min. 9 Nm - max. 11 Nm) (sect. 3 - 3, Engine torque settings). Check t ...

Refitting the cylinder head assemblies
Warning To prevent oil leaks past the contact area between cylinders and crankcase, each time the head is removed, cylinder and piston must be removed as well to clean the mating faces of crankcase and cylinder and restore the spoiled gaskets and o-rings and apply again liquid sealant (sect. ...

Specific operating strategies
Idle speed No electric motor is used for idle speed regulation (bypass is modulated instead with the throttle valve), as idle speed control is effected by the ride-by-wire system. Idle speed is maintained by the control unit when the speed drops below a specific threshold and when the clutch ...

2024 | www.dudiavel.com |