Important
Have the air filter maintenance performed at a ducati dealer or authorised service centre.
Cooling circuit capacity: 2.5 Cu. Dm (litres).
Warning
This operation must be carried out with the engine cold and with the motorcycle vertical and level.
Checking and topping up coolant levelClutch lever button
Introduction
The clutch button is located on the clutch lever. Together with the signal
from the side stand button and the neutral signal
generated by the gear sensor (transmitted to the engine control unit over the
can line), the clutch lever position signal is
used to enable or disable engi ...
Checking brake and clutch fluid level
The levels should not fall below the min marks on the
respective reservoirs.
If the level is too low, air can get into the circuit, thus
impairing the efficiency of the system.
Brake and clutch fluid must be topped up and changed at the
intervals specified in the scheduled maintenance table ...
Reassembling the front footrest brackets
To remove the front rh footrest bracket (6) it is necessary to remove the
rear brake master cylinder reservoir (by leaving
it connected to the braking system), and the rear brake lever from the bracket
(sect. 7 - 4, Removing of the rear brake
control).
To remove the front rh footrest bracke ...