Important
Have chain tension adjusted by a ducati dealer or authorised service centre.
Make the rear wheel turn until you find the position where chain is tightest.
Set the vehicle on the side stand. Push down the chain at the point of measurement and release.
Measure the distance between the "aperture" upper profile and pin centre.
The read distance must be: 9 ÷ 11 mm.
Important
If the drive chain is too tight or too slack, adjust it so that tension reading will fall within specified range.
Warning
Correct tightening of screws (1, fig. 149) Is critical to rider and passenger safety.
Important
Improper chain tension will lead to early wear of transmission parts.
Default function (resetting ducati default parameters)
This function resets the parameters set by ducati for each
riding style.
To access the function it is necessary to view the "setting" menu page 48, using
button (1, fig. 14) ?"
" or (2, fig. 14) ?" " select the "riding mode"
function and press the
r ...
Cylinder compression test
Note
The on-screen icons used during this procedure are explained in a table at
the end of this section.
Engine performance is directly correlated to the pressure that can be
measured in the combustion chambers of the two
cylinders. Pressure which is too high/low or an excessive difference be ...
Headlight aim
The motorcycle must be perfectly upright with the tires inflated to the
correct pressure and with a rider seated, perfectly
perpendicular to the longitudinal axis.
Position the motorcycle 10 metres from a wall or a screen.
On the wall or surface, draw a horizontal line at the same height fr ...