Ducati Diavel Owners Manual: Controls
Warning
This section shows the position and function of the controls used to ride the motorcycle. Be sure to read this information carefully before you use the controls.
- Position of motorcycle controls
- Hands free system
- Hands free system key-on and key-off
- Key-on/key-off using the red key on the handlebar with the active key
- Key-on/key-off using the key on the hands free lock with the active key
- Key-on/key-off using the red key on the handlebar with the passive key
- Key-on/key-off using the key on the hands free lock with the passive key
- Key-on/key-off using the pin code (immobilizer release)
- Entering pin code function for vehicle release
- Lh switch
- Clutch lever
- Rh switch
- Throttle twistgrip
- Front brake lever
- Rear brake pedal
- Gear change pedal
- Adjusting the position of the gearchange and rear brake pedals
Steering lock on indication
This function informs that the steering lock was turned on.
The steering lock can be turned on during the first 60
seconds after turning off the vehicle by pressing down on the
"run" bu ...
Position of motorcycle controls
Instrument panel on handlebar.
"Hands free" system.
Instrument panel on tank.
Left-hand handlebar switch.
Clutch lever.
Rear brake pedal.
Right-hand handlebar switch.
Th ...
Other materials:
Description of the diagnosis instrument (dds)
The "dds" diagnostic system lets you diagnose any faults in the
injection-ignition system via a serial port. The system is
also equipped with functions to test various devices on the motorcycle. The dds
diagnosis instrument can be used to
measure current and voltage on any electrical device, t ...
Renewal of the headlight
Disconnect the headlight connectors (a) from the main wiring (refer to the
tables of paragraph "routing of wiring on
frame", sect. 6 - 1).
Loosen nuts (2) that fix the front optical unit to the bottom yoke, and
recover the washers (3).
Remove the complete front optical unit by sliding ...
Disassembly of the gearchange mechanism
Refer to the exploded view at the beginning of this section for indications
on disassembly and renewal of gearchange
components.
If the bushing (2) inside the pedal (1) needs replacing, grease the external
surface and drive the new bushing into place
using a press. The bushing must be seate ...