Ducati Diavel Service Manual: Cooling system

Refitting the lubrication system

Note Before fitting the pipes (7), it is recommended to check the presence of the o-rings (e). Lubricate them by using engine oil. If the nipples (5) have been removed from the radiator inser ...

Coolant expansion tank

Plug Screw Fuel filler flange Clip nut Clamp Hose clip Valve/tank hose Clamp Screw Spacer Rubber mounting Expansion reservoir Filler cap Hose clip Support Screw ...

Other materials:

Steering release error - steering still locked
The activation of this (amber yellow) "warning" indicates that the hands free system was not able to extract the steering lock. Warning In this case, ducati recommends turning the vehicle off and on (key-off / key-on) holding the handlebar pressed down to the end stop. If the signal ...

Check the engine oil pressure
Note The on-screen icons used during this procedure are explained in a table at the end of this section. To measure the pressure of the lubrication circuit, use the engine oil pressure test point (19) as described below. Disconnect the wiring connector (f) of pressure switch (1) and rem ...

Replacing the tank flange and fuel sensor
Loosen the screws (19) securing the fuel tank flange (20). Remove the flange (20) from the tank (20). Recover the seal (21). Undo and remove the two fixing screws (g) and move the protection (f). Before reassembly, carefully remove any deposits or scale from all parts. Note The flang ...