Ducati Diavel Service Manual: Disassembly of the camshaft pulleys

Removing of the cylinder head pulley/fixed tensioner

Insert the tool code 88713.1806 In the pulleys to lock their rotation and use the bush supplied to loosen the fixing nuts (21) of the pulleys. important On reassembly, always use new nuts. Remov ...

Removing the timing belt driveshaft pulleys

Use the tool code 88713.1805 To hold the driving pulley on the engine crankcase against rotation. Important If this operation is carried out with the engine installed in the frame, hold the driv ...

Other materials:

Refitting the rear brake control
If the pushrod (18), clip (30) and fork (31) assembly has been dismantled, reassemble it by screwing the nut (29) onto the rod (18) and then screw the rod into the fork (31) to obtain the measurement indicated in the figure. Block the rod and tighten to a torque of 7.5 Nm +/- 10% (sect. 3 - ...

Check the idle and the co amount with warm engine
Start the engine; Switch on the dds and check that it does not signal any error (otherwise consult the relevant paragraph of this manual to reset the error and proceed with the idle check); Enter the "self diagnosis" menu by selecting the diavel model in the available vehicle version. ...

Removal of the licence plate holder
Disconnect connector (5) of the number plate holder wiring from the main one. Release the number plate holder light cable from the ties and the cable grommets as indicated in sect- 7 - 6, flexible wiring/hoses positioning, since the cable is together with the rear abs sensor cable. ...