Ducati Diavel Owners Manual: Ducati limited warranty on emission control system
Ducati north america, inc., 10443 Bandley drive cupertino, california, 95014 warrants that each new 1998 and later ducati motorcycle, that includes as standard equipment a headlight, tail-light and stoplight, and is street legal: a) is designed, built and equipped so as to conform at the time of initial retail purchase with all applicable regulations of the united states environmental protection agency, and the california air resources board; and b) is free from defects in material and workmanship which cause such motorcycle to fail to conform with applicable regulations of the united states environmental protection agency or the california air resources board for a period of use of 30,000 kilometers (18,641 miles) or 5 (five) years from the date of initial retail delivery, whichever first occurs.
California emission control warranty statement
Your warranty rights and obligations
The california air resources board is pleased to explain the
emission control system warranty on your my 2011
motorcycle. In california, new motor vehicles must ...
Coverage
Warranty defects shall be remedied during customary
business hours at any authorized ducati motorcycle dealer
located within the united states of america in compliance
with the clean air act and ap ...
Other materials:
Checking and overhauling the components
Clearance between the clutch drum and friction plates
Insert a friction plate (e) in the clutch drum (f) and measure the clearance
(s) with a feeler gauge.
Clearance "s" must not exceed 0.6 Mm.
If it does, renew the plates and, if necessary, the clutch drum.
Overhaul of the clutch plat ...
Key-on/key-off using the key on the hands free lock with the active key
Key-on can be performed by pressing the button (7) on the
hands free lock (1, fig. 77) And with the presence of the
active key (3, fig. 77).
Note
The active key (3, fig. 77) Has a range of approx. 1.5 M,
therefore it must be located within this range.
Key-off can be performed by pressing the ...
Refitting the filler cap
Position seal (18) in tank cap (10) as shown and reassemble following the
removal procedure in the reverse sequence.
In particular tighten the screws (17) to a torque of 3 nm +/- 10% (sect. 3 - 3,
Frame torque settings).
...