Ducati Diavel Service Manual: Engine

Refitting the evaporative emissions canister

To refit, carry out the removal operations in reverse order, making sure to locate the hoses as shown in the figures at the end of the chapter. Positioning the hoses / clamps and canister filt ...

Removal-refitting of the engine assembly

Screw Special screw Nut Screw Swingarm pivot Special screw Washer Spare parts catalogue Diavel abs frame Diavel abs swingarm Diavel carbon abs frame Diavel carbon abs swi ...

Other materials:

Reassembly of the gearbox shafts
Figure 1 shows all the parts to be reassembled on the gearbox primary shaft (2), with the calculated end shims (1) and (11) (sec. 9 - 9.2, Reassembly of the crankcase halves). Figure 2 shows all the parts to be installed on the gearbox secondary shaft (25), with calculated end shims (15) a ...

Air temperature sensor
Introduction The engine control system on the diavel uses a sensor that measures air temperature. This sensor has a resistance of ntc type (negative temperature coefficient), that reduces its own value when the temperature increases. The air temperature sensor allows the engine control unit t ...

Replacing the rear phonic wheel sensor
Disconnect the rear abs sensor (5) connector (c) from the main electric wiring. Open all the retainer clamps of the rear abs sensor cable (5): refer to table of sect. 7 - 6, Flexible wiring/hoses positioning. Remove the rear abs sensor (5) from its seat on the rear calliper mounting ...