This function customises engine power and output.
To access the function it is necessary to view the "setting" menu page 48, using
button (1, fig. 14) ?"
"or (2, fig. 14) ?" "select the "riding mode"function
and press the
reset button (12, fig. 12) To go to next page.
Use button (1, fig. 14) ?" "or (2,
fig. 14) ?" "to select the riding
mode to be changed and press the reset button (12, fig. 12) To access the next
page. Now use button (1, fig. 14) ?"
"and (2, fig. 14) ?"
"to select the "engine" indication
and press the reset button again (12, fig. 12) To confirm
selection.
When accessing the function, the engine setting (engine 162 high, 162 low o 100 hp) appears at the right-hand side of the display, inside a rectangle.
Note
In japan and france versions, the display displays the settings (engine high, middle or low).
Using button (1, fig. 14) ?"" or
(2, fig. 14) ?" " select one of
the three available engine settings; after selecting the new
setting, press the reset button (12, fig. 12) To highlight
"memory" indication.
At this point, store the new setting by pressing and holding the reset button (12, fig. 12) For 3 seconds with "memory" displayed. If the setting has been stored successfully, the display will show "memorized" in green for 2 seconds and the exit option will be highlighted automatically.
To exit the setting function, press the reset button (12, fig.
12) Where "exit" is highlighted.
Reassembling the front footrest brackets
To reassemble the brackets (6) and (21) carry out the removal procedure in
the reverse order; tighten the screws (7) to a
torque of 25 nm +/- 10% (sect. 3 - 3, Frame torque settings).
...
Adjusting the throttle cable
The throttle grip in all steering positions must have free play, measured on
the periphery of the flange of the grip, of 1.5 -
2.0 Mm.
If necessary, adjust using the adjusters (1) and (2) located on the steering
tube on the right side of the motorcycle.
Adjuster (1) adjusts the throttle o ...
Trip 1 meter
This function shows the distance travelled since the trip meter was last
reset (in km or miles depending on the specific
application).
Press and hold (1) "s" for 3 seconds while in this function to reset the trip
odometer.
When the reading exceeds 9999.9, Distance travelled is reset and t ...