Ducati Diavel
Free Service and Repair manuals

Ducati Diavel Service Manual: Flywheel - alternator

Ducati Diavel Service Manual / Engine / Flywheel - alternator

Flywheel - alternator


  1. Screw
  2. Alternator stator
  3. Plug
  4. Sealing ring
  5. O-ring
  6. Cover
  7. Screw
  8. Aluminium gasket
  9. Screw
  10. Bracket
  11. Locating bush
  12. Screw
  13. generator cover
  14. Flange
  15. Flanged nut
  16. Plane washer
  17. Flywheel
  18. Washer
  19. Inner ring
  20. Needle roller bearing
  21. Electric starter driven gear
  22. Starter clutch
  23. Circlip
  24. Alternator rotor
  25. Screw
  26. screw
  27. Bearing

Spare parts catalogue

Diavel abs water pump-altr-side crankcase cover

Diavel abs electric starting and ignition

Diavel abs connecting rods

Diavel carbon abs water pump-altr-side crankcase cover

Diavel carbon abs electric starting and ignition

Diavel carbon abs connecting rods

Important

Bold reference numbers in this section identify parts not shown in the figures alongside the text, but which can be found in the exploded view diagram.

Reassembly of the gearbox
To refit the gearbox components follow the procedure under sect. 9 - 9.2, Reassembly of the crankcase halves, relating to reassembly of the engine crankcase. As a final practical test, ensure th ...

Removal of the generator cover
Note This operation is described for an engine removed from the frame since all reassembly procedures are easier with the engine on the bench. Disconnect the connector (a) from the generator ...

Other materials:

Removing of the cylinder head pulley/fixed tensioner
Insert the tool code 88713.1806 In the pulleys to lock their rotation and use the bush supplied to loosen the fixing nuts (21) of the pulleys. important On reassembly, always use new nuts. Remove the nuts (21) and the pulleys (11) from the camshafts. Loosen the nut (8), and remove the was ...

On/off switch on handlebar
Introduction The on/off switch on the handlebar is used to switch the dashboard on and off, if a key has been detected, and start the engine. With the switch turned to "run off" (centre position), pushing downwards switches the dashboard on or off (activating the button inside the switch). ...

Refitting the radiator
The reassembly procedure is the same for both radiators. Check for the nuts with clips (8). Refit the rh radiator (13) on the frame and tighten the screws (4) and (5) with the spacers (6) to a torque of 10 nm +/-10% (sect. 3 - 3, Frame torque settings). Connect the connections of ...

2026 | www.dudiavel.com |