Ducati Diavel Service Manual: Front and rear mudguard

Refitting the seat

Note Apply recommended grease to the hole (a) of latch (6). Fit the seat (1) as follows: insert the tabs (b) (on the front side) under the rubber pads (c) of the gloves compartment; then push ...

Removal of the front mudguard

Undo the screw (7) and remove the front brake lines (a) from the hose grommet (4). Undo and remove the special retaining screws (5): keep the spacers (6). Remove the front mudguard (1). War ...

Other materials:

Default function (resetting ducati default parameters)
This function resets the parameters set by ducati for each riding style. To access the function it is necessary to view the ""setting" menu", using buttons (1) "s" or (2) "t" select the "riding mode" function and press the reset button (3) to enter the following page. Use button (1) "s" or ...

Removal of the cylinder/piston assembly
Loosen the clamps (7) and remove the hoses (8) and (9) from the cylinder barrels (10) and from the alternator-side crankcase cover. If damaged, unscrew the unions (6). Note The following procedure is described with the engine removed from the frame and the cylinder head r ...

Refitting the gearchange mechanism
Make sure that the gearchange linkage assembly (6) is installed with the ball joint with a left-hand thread (a) facing the lever (8). Apply the recommended grease to the non-threaded surface of the pin (4). Fit the first o-ring (5) in the pin (4). Start the pin (4) in the gearchange leve ...