Ducati Diavel Service Manual: Fuel/exhaust system

Refitting the tail light

Fit the spacers with collar (3) into the rear vibration dampers (2) located on the gloves compartment (23). Note Two spacers (3) must be inserted inside and outside on the right side and two spa ...

Fuel tank

fuel tank Rubber pad Spacer Screw Hose Tray Y-fitting Hose Hose Filler cap Screw Complete hose guide Screw Hose clip Hose Screw Screw Sealing washer Screw ...

Other materials:

Removal of the swingarm
Before removing the parts in question, you must first carry out the following operations: Remove the rear wheel eccentric hub as described in chapter "removal of the rear wheel eccentric hub and rear wheel shaft" of this section. Loosen screws (7) and remove the hose grommets (13), (15) ...

Anti-pollution system and auto-adaptive strategy
Efficacy of the catalytic converter and oxygen sensors To comply with current emissions legislation, the diavel is equipped with a trivalent catalytic converter, which oxidises co (carbon monoxide) and hc (unburnt hydrocarbons) and reduces nox (nitrogen oxides). The image shows the exhaus ...

Refitting the gear selector lever
Position the gearbox drum selector fork in the centre of the gear rollers. Position the gear selector lever (21) together with control shaft, spring and plate into the chain-side crankcase half. Insert the screws (18) and (20) with the spacer (19). Temporarily fit gear change lever (or a ...