Ducati Diavel Service Manual: Gearchange mechanism
- Return spring
- Washer
- Special screw
- Gear pawl assembly
- Interlock plunger holder
- Sealing washer
- Detent ball spring
- Ball
- Circlip
- Selector claw return spring
- Shim washer
- Ring
- Nut
- Selector drum control fork
- Gearchange lever pin
- Shaft with gearchange lever arm
- Gearchange lever arm return spring
- Screw
- Spacer
- Screw
- Gearchange mechanism
- Locating ring
- Stop plate
- Shim washer
Spare parts catalogue
Diavel abs gearchange control
Diavel carbon abs gearchange control
Important
Bold reference numbers in this section identify parts not shown in the figures alongside the text, but which can be found in the exploded view diagram.
- Removal of the gear selector lever
- Disassembly of gear interlock plunger and pawl assembly
- Refitting the gear interlock plunger and pawl assembly
- Refitting the gear selector lever
Gearbox assembly
...
Removal of the gear selector lever
Unscrew and remove the fixing screws (18) and (20) of the complete gear
selector lever (21) and collect the spacer (19).
Remove the gearchange mechanism complete with the shaft, spring, and s ...
Other materials:
Adjusting the steering head bearings
Excessive handlebar play or shaking forks in the steering head indicate that
the play in the steering head bearings
requires adjustment. Proceed as follows:
loosen the clamp screw (1) that holds the steering tube to the steering head.
Slacken the clamp screws (2) securing the steering head ...
Overhaul of the connecting rods
Make the following dimensional checks on the connecting rods:
Clearance with gudgeon pin on assembly.
In the event of excessive wear (sect. 3 - 1.1, Crankshaft), replace the
connecting rod.
The small end bushing must be in good condition and firmly driven into its seat.
Check for para ...
Removal of the cylinder/piston assembly
Loosen the clamps (7) and remove the hoses (8) and (9) from the cylinder
barrels (10) and from the alternator-side
crankcase cover.
If damaged, unscrew the unions (6).
Note
The following procedure is described with the engine removed from the
frame and the cylinder head r ...