Note
The on-screen icons used during this procedure are explained in a table at the end of this section.
The dds diagnosis instrument guides the operator step-by-step through the various diagnostic procedures, providing descriptions and documentation for motorcycle components, wiring diagrams for the electronic systems and information on the locations of specific components.
Turn on the dds diagnosis instrument (1) referring to the paragraph "tester power supply".
Connect the power and diagnosis cable (2) part no. 97900.0227 To the diagnosis connector (f) to the diagnosis socket (3) of the motorcycle.
Enter the general functions menu by pressing the icon "menu 1" (a).
Press the "select vehicle" icon and, on the next screen, press the "select motorcycle" icon; select the motorcycle model and confirm, then select the version and confirm.
Press the icon "select system" to display a list of the bike’s systems that can be analysed.
Select one of the options shown in the following picture and press icon "confirm" (b) to confirm it.
Press the "guided diagnosis" icon (c) to access the corresponding function.
A series of screens are displayed indicating the operations required for correct diagnosis.
To determine whether the system has any internal problems, you can access the "self-diagnosis" function by pressing the corresponding icon. If any errors are present, the symbol (d) will be displayed. To determine the type of errors present, press the "errors" icon (e). Once errors are detected, it is possible to solve them using the step-by-step diagnosis; press "step-by-step diagnosis" icon (c).
The dds diagnosis instrument will interrogate the electronic control unit and display the parameters analysed with their relative values.
Vehicle speed indicator
this function displays vehicle speed (km/h or mph
depending on the set measurement system).
the instrument panel receives information about the actual
speed and displays the number increased by 5%.
maximum speed displayed is 299 km/h (186 mph).
over 299 km/h (186 mph) a series of dashes w ...
Checking valve lift
Set the engine to the configuration described for the "checking and adjusting
the valve clearances", previously indicated.
Position the tool 88765.1518 On the cylinder head: the part marked "a" should be
on the intake side and the part
marked "s" should be on the exhaust side.
Seat the pl ...
Refitting the timing gears
Before reassembling the removed parts, check timing gears (13) for wear.
Change, if necessary.
Important
The timing gears (13) must always be renewed as a pair.
Refitting is the reverse of removal.
Warning
When introducing the driven gear (b) check that the tongue (15) is
correctly fitted o ...