Key-on consists in turning on the hands free system and all of its electronic devices.
Key-off consists in turning off the hands free system and all electronic devices, and makes sure the engine is turned off.
Key-on is done using the button (6) on the handlebar on the right switch or using the emergency button (7) on the hands free lock (1, fig. 77).
Key-off is done using the button (6) on the handlebar on the right switch or using the button (7) on the hands free lock (1, fig. 77).
Note
The use of one of the two buttons (6) or (7) does not exclude the other, ex.: If i turn it on with one, i can turn it off with the other and vice versa.
Key-on can only occur in the presence of one of the two keys (3, fig. 77) Or (4, fig. 77) Or using the pin code.
Key-off can also occur without a key (3, fig. 77) Or (4, fig. 77).
Key-off occurs when the speed of the motorcycle is equal to zero, pressing the button (6) on the handlebar or by pressing the hands free button (7); at a speed other than zero, only by pressing the hands free button (7).
Note
With the vehicle in key-on and "engine off", if the presence of the active key (3, fig. 80) Is not detected for thirty consecutive seconds, the motorcycle will turn off automatically without any action by the rider.
Refitting the silencer
Position the silencer guard (41) and fix it by starting the screws (40).
Tighten the screws (40) to a torque of 8 nm +/- 10% (sect. 3 - 3, Frame torque
settings).
Insert the silencer (4) into the central exhaust pipe (26), and fix it to the
vehicle by starting the screw (1).
Hold the ...
Refitting the gearchange mechanism
Make sure that the gearchange linkage assembly (6) is installed with the ball
joint with a left-hand thread (a) facing the
lever (8).
Apply the recommended grease to the non-threaded surface of the pin (4).
Fit the first o-ring (5) in the pin (4).
Start the pin (4) in the gearchange leve ...
Trip 2 meter
This function shows the distance travelled since the trip
meter was last reset (in km or miles depending on the
specific application).
Holding the button (1, fig. 14) ?
pressed for 3 seconds
when this function is displayed resets the trip meter.
When the reading exceeds 9999.9, Distance t ...