Ducati Diavel
Free Service and Repair manuals

Ducati Diavel Service Manual: How to start the motorcycle if the active key is not working

Ducati Diavel Service Manual / Electric system and engine control system / The hands free system / How to start the motorcycle if the active key is not working

If no keyboard is detected, the dashboard does not switch on. Ensure that the active key is within the operating range of 1.5 Metres and that the key battery is charged. If the state of charge of the key battery is not known, place either the active or passive key on the seat and start the motorcycle normally while keeping the key in this position.

The photo illustrates where to place the passive key or the active key, if its battery is flat.

How to start the engine
With the motorcycle off and the dashboard on, the on/off switch is turned to "run off" With the motorcycle and dashboard on, the on/off switch is turned to "run off". To start the engine, ...

How to start the motorcycle without keys
To start the motorcycle when necessary with no active or passive key, switch the dashboard on by pressing the button on the hands free system (located under the plastic shield at the front of the ...

Other materials:

Reassembly of the gearbox
To refit the gearbox components follow the procedure under sect. 9 - 9.2, Reassembly of the crankcase halves, relating to reassembly of the engine crankcase. As a final practical test, ensure that with the gearbox in neutral the front coupling dogs (a) of sliding gears (b) are equidistant o ...

Refitting the gear selector lever
Position the gearbox drum selector fork in the centre of the gear rollers. Position the gear selector lever (21) together with control shaft, spring and plate into the chain-side crankcase half. Insert the screws (18) and (20) with the spacer (19). Temporarily fit gear change lever (or a ...

Refitting the rear-view mirrors
Start the screws (2) in their thread on the rear-view mirrors (1), inserting the washers (4) as shown in the picture. Insert the rear-view mirrors (1) in the u-bolts (3). Tighten the screws (2) to a torque of 25 nm +/-10% (sect. 3 - 3, Frame torque settings). Warning The left rear-view ...

2026 | www.dudiavel.com |