To start the motorcycle when necessary with no active or passive key, switch the dashboard on by pressing the button on the hands free system (located under the plastic shield at the front of the tank). The dashboard switches on and remains active for 2 minutes after the button is pressed to allow entry of the pin code for starting the engine. For further information consult chapters "recovery and emergency procedures - start procedure with pin code (no keys)" of this section.
How to start the motorcycle if the active key is not working
How to turn the motorcycle offStarter motor relay
Introduction
When the rider presses the start button, with all the safety conditions
required to enable engine start met, the engine
control unit enables the relay that activates the starter motor.
Component assembling position
Connection on starter motor relay.
Connection wiring diagram
...
Refitting the timing belt driveshaft pulleys
To fit the circlip (10) in the driveshaft seat, use the tool code 88713.2834.
Install the inner spacer (17) on the driveshaft, taking care to align the
notch in the spacer with the slot for the woodruff
key.
Fit the first woodruff key (16) on the timing belt driveshaft.
Locate the ...
Refitting the side stand
Place the stand plate on the rear shock absorber support; bring adjuster (14)
in line with bracket (s) and start the screw
(12) in the nut behind the bracket (s).
Insert the screws (11), (3) and (10) fully home in this order, but do not
tighten.
Loosen the screw (12) with the relative nut ...