Ducati Diavel Service Manual: How to switch the dashboard on
The dashboard may switched on either from the on/off switch on the handlebar or from the button on the hands free system.
With the engine off, the on/off switch is turned to "run off".
With the motorcycle and dashboard off, the on/off switch is turned to "run off".
To switch the dashboard on, press the on/off switch on the handlebar downward. When released, the switch automatically returns to the "run off" position. If the key is detected, the dashboard switches on and the electric steering lock is disengaged (if engaged previously).
Press the on/off switch on the handlebar downward. When released, the switch automatically returns to the "run off" position. If the key is detected, the dashboard switches on and the steering lock is disengaged (if engaged previously).
The dashboards may also be switched on with the on/off button on the hands free system. In this case you just have to press once the button located in the tank front side.
Note
In the usa version the door (1) is not present.
If the key is not detected within 10 seconds of switching the dashboard on, the dashboard switches off automatically.
Operating principle
Introduction
The hands free system features two separate on/off buttons, either one of
which may be used as preferred by the rider.
For practical reasons, we recommend using the button on the ha ...
How to start the engine
With the motorcycle off and the dashboard on, the on/off switch is turned to
"run off"
With the motorcycle and dashboard on, the on/off switch is turned to "run
off".
To start the engine, ...
Other materials:
Tips for use on the track
We recommend level 8 be used for a couple of full laps (to
allow the tyres to warm up) in order to get used to the
system. Then try levels 7, 6, etc., In succession until you
identify the dtc intervention level that suits you best (always
try each level for at least two laps to allow the tyres t ...
Overhaul of the crankcase halves
Carefully examine the engine crankcase halves.
Check that the surfaces of the crankcase halves are perfectly flat using a
reference surface.
Check that the bearings (1) and (18), and the bushings (2) and (17) are in
optimum conditions. Note that the main
bearings must always be changed in p ...
Overhaul of the gearbox
Check the condition of the front coupling dogs of the gears. They must be in
perfect condition and with no sign of wear on
the edges of the teeth.
The idler gears must rotate freely on their shafts.
When refitting, make sure the circlips are correctly positioned.
Check the needle roller ...