Ducati Diavel Service Manual: Hydraulic clutch control
- Special screw
- Sealing washer
- Clutch master cylinder
- Clutch hydraulic pipe (metal braid)
- Screw
- Spare stand
- Washer
- Microswitch
- Pin
- Bleed valve
- Screw
- Roller
- O-ring
- Clutch control rod
- Clutch lever
- Dust cap
- Bleed valve
- Special screw
- Sealing washer
- Boot
- Plug
- Fluid reservoir assembly
- Inspection plug (replacement part)
- Union
- Oil duct union
- Insert
- Hose clip
Spare parts catalogue
Diavel abs clutch control
Diavel abs clutch
Diavel carbon abs clutch control
Diavel carbon abs clutch
Important
Bold reference numbers in this section identify parts not shown in the figures alongside the text, but which can be found in the exploded view diagram.
- Removal of the clutch master cylinder assembly
- Refitting the clutch master cylinder assembly
- Removal of the clutch transmission unit
- Refitting the clutch transmission unit
Refitting the throttle twistgrip
Lubricate the ends of the throttle grip cables (10) and the twistgrip race
with the recommended grease.
The closing cable (10) features a writing on the yellow tube, whereas the
opening one (10 ...
Removal of the clutch master cylinder assembly
Warning
The clutch master cylinder manufacturer advises against servicing of
the clutch master cylinder (1) due to the safetycritical
nature of this component. Incorrect overhaul of this component ...
Other materials:
Refitting the rear brake calliper
When replacing the brake pipes (33) or removing one of the rear braking
system components, pay special attention to the
position of the couplings on the pump and the calliper.
Warning
If incorrectly positioned, the hose can affect brake operation and
foul moving parts. Position the hose as sh ...
Reassembly of rear shock absorber - rocker arm - linkage assembly
Once the needle roller bearings (9) have been removed from the rocker arm
(18), upon reassembly fit a new needle roller
bearing (9) on drift part no. 88713.1071 And lubricate with recommended grease.
Support the rocker arm and drive the needle roller bearings into the rocker arm
bore until t ...
Side stand button
Introduction
The side stand button is located on the side stand. Together with the signal
from the clutch button and the neutral signal
generated by the gear sensor (transmitted to the engine control unit over the
can line), the side stand position signal is
used to enable or disable engine s ...