Ducati Diavel
Free Service and Repair manuals

Ducati Diavel Owners Manual: Indicator air - air temperature

Ducati Diavel Owners Manual / Instrument panel (dashboard) / Indicator air - air temperature

This function shows the external temperature.

Display limits: -39C ÷ +124C

In the event of a sensor fault (-40C,+125C or disconnected), a string of dashes "- - -" (not flashing) is displayed and the "engine/vehicle diagnosis - eobd" light (7, fig. 4) Comes on.

Indicator air - air temperature


Note


When the vehicle is stopped, the engine heat could influence the displayed temperature.

When the detected temperature drops to 4C (39f), the display warns that the formation of ice is possible. The indication turns off when the temperature rises to 6C (43f).

Warning


This warning does not exclude the possibility of icy road sections even at temperatures above 4C (39f); when external temperatures are "low" it is always recommended to ride carefully, particularly on sections that are not exposed to the sun and/or on bridges.

Indicator air - air temperature


Indicator trip time - trip time
This function shows the vehicle trip time. The calculation is made considering the time travelled since the last trip 1 reset. When trip 1 is reset, the value is set to zero. The active phase ...

Engaged gear indicator
This function displays the gears (1, fig. 25). The instrument panel receives information and indicates the engaged gear or "n" for neutral. Note In the case of a gear sensor "err ...

Other materials:

Removal of the exhaust system
Remove the silencer, as described in the paragraph "removing the silencer" of this section. Loosen the screws (28) and remove the exhaust by-pass valve cover (27). Turn the exhaust valve pulley (a) to facilitate the throttle cable (25) output. Release the end fitting (b) of the cable ...

Reassembly of the timing pulleys
Fit the pulley (11) on the flange (24), aligning the timing mark (d) on the pulley with the timing mark on the (e) on the flange. Install the washer (23) up against the pulley, aligning the timing notch (f) with the timing marks on the pulley and the flange. Insert the three screws (22) ...

Front brake control
Front brake master cylinder Brake lever Special screw Sealing washer Screw Phonic wheel Brake disc Pin Left brake calliper Boot Bleed valve Spare stand Control unit - front callipers pipe Microswitch Oil duct union Screw Hose clip Right brake calliper Speci ...

2026 | www.dudiavel.com |