Ducati Diavel Service Manual: Introduction to the electrical system of the diavel
- On-board computers and the can line
- Fault indication
- Operating principle of dtc
- Riding modes
- The battery charging circuit and power distribution
- Ground connection locations
- Electrical power for lighting and signalling devices
- Location of elements on motorcycle
Oxygen sensors
Introduction
An on-off type oxygen sensor (in normal operating conditions, the voltage
generated by the sensors switches between a
value close to 1v and a value close to 0v) is mounted on each of ...
On-board computers and the can line
The following on-board computers make up the electrical system of the diavel
and are connected with each other via the
can line (or network):
Master dashboard
Slave dashboard
Hands free (fa ...
Other materials:
Overhauling the rear wheel
Inspect the condition of the rear wheel.
As the wheel rim has no bearings, it should be supported using the service tool
code 88713.2951.
Note
This service tool can also be used to install the wheel on a balancing
machine.
Overhauling the wheel
Inspect the wheel as described below.
...
Component assembling position
The throttle valve position sensor is integrated in the throttle valve
actuator motor.
Location of electric connection for throttle valve actuator motor - tps
(throttle valve position sensor).
Connection wiring diagram
Ccm engine control connection, s throttle valve position senso ...
Clock setting function
This function sets the clock.
To access the function it is necessary to view the "setting" menu page 48, using
button (1, fig. 14) ?"
"or (2, fig. 14) ?""select the "clock"function and
press the reset button
(12, fig. 12) To confirm.
In the follow ...