Ducati Diavel Service Manual: Key to wiring diagram
- Right-hand handlebar switch
- Immobilizer
- Hands free relay
- Hands free
- Front fuse box
- Right fan
- Left fan
- Fan relay
- Fuel pump relay
- Ride-by-wire relay (etv)
- Injection control unit (ems)
- Rear fuse box
- Data acquisition/diagnosis
- Starter motor
- Fused solenoid
- Battery
- Wiring ground
- Regulator
- Generator
- Fuel pump
- Fuel level
- Rear right turn indicator
- Rear light
- Rear left turn indicator
- Vehicle control unit (bbs)
- Antitheft alarm
- Exhaust valve starter motor
- Gear sensor
- Rear speed sensor
- Abs control unit
- Throttle twistgrip position sensor (aps)
- Starter motor - position sensor / ride-by-wire (tps/etv)
- Timing/rpm sensor
- Vertical map sensor
- Horizontal map sensor
- Engine temperature
- Air temperature sensor
- Vertical lambda sensor
- Horizontal lambda sensor
- Oil pressure switch
- Rear stop
- Side stand switch
- Clutch switch
- Front stop
- Main vertical injector
- Main horizontal injector
- Horizontal coil
- Vertical coil
- Left-hand handlebar switch
- Horn
- Front speed sensor
- Front left turn indicator
- Dashboard on handlebar
- Dashboard on tank
- Front right turn indicator
- Navigator
- High / low beam
- Parking light
Diavel abs wiring diagram
Diavel carbon abs wiring diagram
...
B blue
Bk black
Bn brown
G green
Gr grey
Lb light blue
O orange
P pink
R red
V violet
W white
Y yellow
Rear left fuse box (1) key
Rear right fuse box (2) key
...
Other materials:
Filling the clutch circuit
Warning
Clutch fluid will damage painted surfaces if spilled on them. It is
also very harmful if it comes into contact with the skin or
with the eyes; in the case of accidental contact, wash the affected area
thoroughly with plenty of running water.
Remove cover (1) and membrane from the clut ...
Refitting the rear wheel eccentric hub and rear wheel shaft
Refitting is the reverse of removal, with attention to the following points.
If the calliper bracket locating pin (14) was removed, apply the recommended
threadlocker on reassembly.
Tighten the pin (14) to the torque of 33 nm +/- 5% (sect. 3 - 3, Frame torque
settings).
If previously ...
Refitting the cooling system hoses and unions
Position the pump/radiator sleeve (22) and the radiator/radiator sleeve (23).
Fit sleeve (23) and sleeve (22) to their corresponding fittings (n) and (o), and
bring them fully home on collars (p).
Note
Sleeves (23) and (22) must be oriented so that the grooves (q) match the
tabs (r) on fitt ...