Ducati Diavel Service Manual: Lights and indicating devices

Solenoid starter

Remove the protection cover (a). Undo the screws (2), taking care to collect the spring washers (3). Remove the starter motor-solenoid cable (4) and the solenoid-battery cable (5). Remo ...

Renewal of the headlight

Disconnect the headlight connectors (a) from the main wiring (refer to the tables of paragraph "routing of wiring on frame", sect. 6 - 1). Loosen nuts (2) that fix the front optical unit to th ...

Other materials:

Absolute pressure sensors
Introduction The engine control system of the diavel is equipped with two absolute pressure sensors, with one connected to the intake duct of each cylinder (map 1 cylinder 1 - horizontal - map 2 cylinder 2 - vertical). They are used by the control unit to determine the quantity of fuel to be ...

Replacing the battery in the active key
Only use 3 volt cr 2032 lithium ion batteries. Note The keys do not need to be reprogrammed after replacing the battery. Remove the metal part of the battery. Use a large sized coin to pry open the shells of the plastic grip (2? coin) as shown in fig. 65. Important Insert the coil on ...

Removing the silencer
Loosen the clamp (38) that retains the silencer (4) to the complete exhaust system. While holding the nut (8), loosen the screw (1) and remove the silencer (4) from the motorcycle. Loosen the screws (40) and remove the silencer guard (41). ...