Ducati Diavel
Free Service and Repair manuals

Ducati Diavel Service Manual: Lubrication system

Ducati Diavel Service Manual / Engine / Lubrication system

Refitting the engine
Refitting is the reverse of removal. Important Apply recommended grease and tighten the special screws (6) to a torque of 60 nm +/- 5% (sect. 3 - 3, Frame torque settings). Tighten the nuts (3) ...

Oil pump
Complete oil pump assembly O-ring Circlip O-ring Pump body Circlip Reducer bush Spring washer Screw Screw Spring washer Pump drive gear Key By-pass plug Locating bus ...

Other materials:

Refitting the front brake master cylinder
Insert the front brake master cylinder unit (1) on the right side of the handlebar to bring the terminal internal edge in correspondence to the bolted joints (a). Fit the terminal (12) on the handlebar inserting the screws (15). Tighten the terminal (12) retaining screws to a torque of 10 ...

Helmet cable
Note Helmet cable (2, fig. 104) Can be found inside the tool kit, see "tool kit and accessories" on page 141. Pass the cable through the helmet and insert the end of the cable in the pin (3, fig. 104). Leave the helmet hanging and refit the seat to hold it in place. Warning Th ...

Starter motor relay
Introduction When the rider presses the start button, with all the safety conditions required to enable engine start met, the engine control unit enables the relay that activates the starter motor. Component assembling position Connection on starter motor relay. Connection wiring diagram ...

2026 | www.dudiavel.com |