Ducati Diavel Owners Manual: Operations to be carried out by the dealer
| List of operations to be performed at 1000 km |
| Reading of the error memory with dds on the engine control units, vehicle and abs |
| Change the engine oil |
| Change the engine oil filter |
| Check the indicators and lighting |
| Check the safety devices (side stand switch, clutch lever switch, right switch engine stop switch and gear position sensor) |
| Check the battery charge level |
| Clean the engine oil intake filter |
| Checking the coolant level |
| Check the brake and clutch fluid levels |
| Check brake discs and pad wear |
| Check tyre pressure and wear |
| List of operations to be performed at 1000 km |
| Check the drive chain tension and lubrication |
| Check the freedom of movement of the side and central stand (if installed) |
| Check the tightening of the safety components (ex. Wheel disc nuts, brake callipers, sprocket tightening) |
| Check rubbing points, clearance and freedom of movement of the flexible cables and electric wiring in view |
| road test of the motorcycle, testing the safety devices (ex. abs) |
| Fill out that the service was performed in the warranty certificate |
Operations to be carried out by the dealer
List of operations to be performed every 12000 km / year (first
limit reached)
Reading of the error memory with dds on the engine control units,
vehicle and abs
Change ...
Other materials:
Refitting the radiator
The reassembly procedure is the same for both radiators.
Check for the nuts with clips (8).
Refit the rh radiator (13) on the frame and tighten the screws (4) and (5)
with the spacers (6) to a torque of 10 nm
+/-10% (sect. 3 - 3, Frame torque settings).
Connect the connections of ...
Disassembly of the gearbox shafts
Place the shaft in a vice in such a way as to facilitate the disassembly
operations.
Important
Take care not to invert the positions of the shims on reassembly:
this would potentially lead to jamming when using the gear selector control,
making it necessary to reopen the engine
crankcase.
D ...
Refitting the front brake master cylinder
Insert the front brake master cylinder unit (1) on the right side of the
handlebar to bring the terminal internal edge in
correspondence to the bolted joints (a).
Fit the terminal (12) on the handlebar inserting the screws (15).
Tighten the terminal (12) retaining screws to a torque of 10 ...