Check the presence of clips (1), (9) and (24) on the support (5).
Check the presence of rubber pads (6) and (8) and of cable grommet (7).
Check that the voltage regulator (3) and the solenoid starter (18) are in place on the support (5) with their wiring as shown.
The horn (22) must be fixed to the support (5) tightening the screw (25) to 18 nm +/- 10% (sect. 3 - 3, Frame torque settings).
Check the presence of the grommet (13) on the cover (12).
Fit cover (12) on the support (5) by tightening the screw (23) to a torque of 4 nm +/- 10% (sect. 3 - 3, Frame torque settings).
Fit the electrical components support (5) on the vehicle by engaging it in the retaining pin (b) on the cooler supporting bracket.
Apply the recommended threadlocker to the screw (21).
Start the screw (11) with washer (10) and the screw (21) with spacer (20).
Tighten the screw (11) to a torque of 10 nm +/-10% (sect. 3 - 3, Frame torque settings) and the screw (26) to a torque of 24 nm +/-10% (sect. 3 - 3, Frame torque settings).
Connect the connector (a) of horn (22) to the main wiring.
The mat (15) must be positioned as shown.
Reassemble the following elements located inside the electrical components support:
After installing the battery, position the battery retaining bracket (4) by tightening the screws (32) to a torque of 5 nm +/- 10% (sect. 3 - 3, Frame torque settings).
Check wiring position as described in chapter: "routing of wiring on frame", sect. 6 -1.
Total distance covered indicator: "odometer"
This function shows the total distance covered by the vehicle
(in km or miles depending on the specific application).
At key-on the system automatically enters this function.
The odometer reading is stored permanently and cannot be
reset.
If the distance travelled exceeds 199999 km (or 19 ...
Warning indication (alarms/signals)
The instrument panel activates in real-time some warnings /
malfunction that are not dangerous for the correct operation
of the vehicle.
At key-on (at the end of the check) one or more "warnings"
are displayed if they are active.
When a "warning" is triggered, the indica ...
Removal of the gear selector lever
Unscrew and remove the fixing screws (18) and (20) of the complete gear
selector lever (21) and collect the spacer (19).
Remove the gearchange mechanism complete with the shaft, spring, and stop plate.
Important
Visually inspect the gear selector claw (14) for wear, particularly aroun ...