Ducati Diavel
Free Service and Repair manuals

Ducati Diavel Service Manual: Refitting the air filters

Apply universal sealant in the air duct (2) and (6) groove (d).

Fit seal (7) in the groove (d) having care to place it correctly in the relevant seat so as to avoid abnormal wrinkles.

Refitting the air filters


Pull out the filter cartridge (1) from the seat in the airbox.

Refitting the air filters


Position the rh air duct (2).

Start the screws (1) and the screw (a) with washer (b).

Tighten the screws (1) to a torque of 3.5 Nm +/- 10% (sect. 3 - 3Frame torque settings) and screw (b) to a torque of 10 nm +/- 10% (sect. 3 - 3, Frame torque settings).

Refitting the air filters


Refitting the air filters


Proceed in the same way to refit the lh intake duct (5), and connect the connector (c) of the air temperature sensor (4).

Refitting the air filters


Check that the clips (10) securing hose (11) are positioned as shown.

Refitting the air filters


Refitting the air filters


Refitting the air filters


Removal of the air filters
Work on the vehicle right side, loosen screws (3) that secure the intake duct (2) to the airbox, and the radiator retaining screw (a); recover the washer (b). Remove the intake duct (2). ...

Exhaust system
Screw Bush Vibration damper mount Silencer Washer Screw Bracket Nut Nut Upper heat guard Screw Washer Central heat guard Spacer Clip nut Long exhaust spring Plug ...

Other materials:

Lap activation/deactivation function (lap time)
This function activates and deactivates the lap function (lap time). To access the function it is necessary to view the ""setting" menu", using buttons (1) "s" or (2) "t" select the "lap" function and press the reset button (3) to enter the following page. Function state is highlighted on t ...

Key to wiring diagram
Right-hand handlebar switch Immobilizer Hands free relay Hands free Front fuse box Right fan Left fan Fan relay Fuel pump relay Ride-by-wire relay (etv) Injection control unit (ems) Rear fuse box Data acquisition/diagnosis Starter motor Fused solenoid Battery Wirin ...

Disassembly of the gearbox shafts
Place the shaft in a vice in such a way as to facilitate the disassembly operations. Important Take care not to invert the positions of the shims on reassembly: this would potentially lead to jamming when using the gear selector control, making it necessary to reopen the engine crankcase. D ...

2026 | www.dudiavel.com |