Ducati Diavel
Free Service and Repair manuals

Ducati Diavel Service Manual: Refitting the flywheel-alternator assembly

Ducati Diavel Service Manual / Engine / Flywheel - alternator / Refitting the flywheel-alternator assembly

Fit the roller cage unit (20) with washer (18) and internal ring (19), applying prescribed grease on the washer (18).

Refitting the flywheel-alternator assembly


Install the roller cage assembly (20) with the washer (18) and inner race (19).

Refitting the flywheel-alternator assembly


Install the flywheel assembly (v) with the gear (21), aligning the notches as shown in the photo.

Refitting the flywheel-alternator assembly


Fit the washer (16) on the end of the crankshaft.

Refitting the flywheel-alternator assembly


Apply the recommended threadlocker to the thread on the end of the crankshaft and the nut (15).

Start the nut (15) on the crankshaft.

Lock the flywheel rotation by means of tool number 88713.3367 And tighten the nut (15) to a torque of 330 nm (min.

313 Nm - max. 346 Nm) (sect. 3 - 3, Engine torque settings).

Refitting the flywheel-alternator assembly


Overhaul of the flywheel-alternator assembly
Examine the inner part of alternator rotor (24) for signs of damage. Check that the starter clutch is working properly and that the needle races do not show signs of wear or damage of any kind. If ...

Refitting the alternator-side crankcase cover
Before the assembly make sure that the water pump unit is fitted on the generator cover (sect. 9 - 3.3, Refitting the water pump). If bearing (27) has been removed, lubricate its seat with speci ...

Other materials:

General cleaning
To preserve the finish of metal parts and paintwork, wash and clean your motorcycle at regular intervals, anyway according to the road conditions you ride in. Use specific products, where possible biodegradable. Avoid aggressive detergents or solvents. Use only water and neutral soap to clean ...

Reassembling the clutch
Position the spacer (13). Fit the flat ring (11) and the belleville washer (10) on the clutch center (12), so that the convex side faces the clutch drum. Locate the belleville washer (8). Apply the prescribed grease to the thread of the gearbox primary shaft and the mating surfac ...

Engine temperature sensor
Introduction The engine control system on the diavel uses a sensor that measures the temperature of the coolant (engine temperature). This sensor has a resistance of ntc type (negative temperature coefficient), that reduces its own value when the temperature increases. The engine temperature ...

2025 | www.dudiavel.com |