Warning
Do not use the motorcycle without the front mudguard fitted to avoid the risk of the brake pipes fouling the wheel on braking.
Insert the screws (5) in spacers (6) with recommended threadlocker, as shown in the figure.
Position the front mudguard (1) and start the special screws (5).
Tighten the screws (5) to a torque of 5 nm +/-10% (sect. 3 - 3, Frame torque settings).
Warning
The version provided with carbon mudguards must feature nylon washers (n) instead of the spacers (6).
Place the hose grommet (a) of the front brake hose and the speed sensor cable inside clip (4) as shown in the figure.
Close the clip (4) and tighten the screw (7) to a torque of 0.35 Nm +/- 10% (sect. 3 - 3, Frame torque settings).
Removal of the front brake master cylinder
Warning
The brake master cylinder manufacturer advises against servicing the
brake master cylinder due to the safety critical
nature of this component. Incorrect overhaul of these critical safety components
can endanger rider and passenger safety.
Maintenance operations on these units are l ...
Gear change pedal
When released, the gear change pedal (1, fig. 96)
Automatically returns to rest position n in the centre. This is
indicated by the instrument panel light n (2, fig. 4) Coming on.
The pedal can be moved:
down = press down the pedal to engage the 1st gear and to
shift down. At this point the n ...
Key to wiring diagram
Right-hand handlebar switch
Immobilizer
Hands free relay
Hands free
Front fuse box
Right fan
Left fan
Fan relay
Fuel pump relay
Ride-by-wire relay (etv)
Injection control unit (ems)
Rear fuse box
Data acquisition/diagnosis
Starter motor
Fused solenoid
Battery
Wirin ...