Ducati Diavel
Free Service and Repair manuals

Ducati Diavel Service Manual: Refitting the starter motor gear

Position the washer (20) and the gear (19) in the pin (21) and take the pin into contact with the crankcase half.

Refitting the starter motor gear


Refitting the starter motor gear


Refitting the starter motor gear


Removal of the starter motor idler gear
Slide the gear pin (21) complete with the gear (19) and washer (20). Warning Pay attention to the washer (20) since it may fall inside the crankcase half. At this point, it is possibl ...

Crankcase halves
Bearing Bearing holder bushing Alternator-side crankcase half Bearing Circlip Washer Bearing Sealing ring Bearing Retaining plate Screw Screw Clutch-side crankcase half ...

Other materials:

Pre-ride checks
Warning failure to carry out these checks before riding, may lead to motorcycle damage and injury to rider and passenger. Before riding, perform a thorough check-up on your bike as follows: Fuel level in the tank Check the fuel level in the tank. Fill tank if needed (page 140). Engine oil le ...

Replacing the tank flange and fuel sensor
Loosen the screws (19) securing the fuel tank flange (20). Remove the flange (20) from the tank (20). Recover the seal (21). Undo and remove the two fixing screws (g) and move the protection (f). Before reassembly, carefully remove any deposits or scale from all parts. Note The flang ...

Overhauling the rear swingarm
Inside the swingarm (8), in correspondence with the pivot point on the frame, there is a pair of ball bearings (10) and a spacer (11) on the rh side, and a pair of roller bearings (6), with sealing rings (5), on the lh side. To change the bearings, proceed as follows. Remove the shims ( ...

2026 | www.dudiavel.com |