Ducati Diavel
Free Service and Repair manuals

Ducati Diavel Service Manual: Removing of the rear wheel

Ducati Diavel Service Manual / Chassis / Rear wheel / Removing of the rear wheel

Removing of the rear wheel


Place the motorcycle on the rear service stand and engage the 1st gear.

Remove the clip (6).

Removing of the rear wheel


Using a suitable socket wrench, loosen the wheel nut (1).

Fully unscrew the nut (1), then remove the washer (2) and the spacer (3).

Remove the rear wheel from the motorcycle.

Removing of the rear wheel


Rear wheel
Right-hand wheel nut Washer Spacer Valve Wheel Circlip Spare parts catalogue Diavel abs front and rear wheels Diavel carbon abs front and rear wheels Important Bold reference ...

Overhauling the rear wheel
Inspect the condition of the rear wheel. As the wheel rim has no bearings, it should be supported using the service tool code 88713.2951. Note This service tool can also be used to install the ...

Other materials:

Removing the timing belt driveshaft pulleys
Use the tool code 88713.1805 To hold the driving pulley on the engine crankcase against rotation. Important If this operation is carried out with the engine installed in the frame, hold the driveshaft pulleys against rotation using the tool code 88713.2011 Mounted on the alternator cover. Lo ...

Fairings
Rh front half-fairing Clip Screw Right-hand support Screw Screw Rh air inlet Lh air inlet Screw Clip Left-hand support Lh front half-fairing Lh tank fairing Screw Nylon washer Special screw Washer Spacer Spring Rubber pad Rh tank fairing Tank fairing ...

Adjusting the chain tension
Make the rear wheel turn until you find the position where chain is tightest. Set the vehicle on the side stand. Push down the chain at the point of measurement and release. Measure the distance between the "aperture" upper profile and pin centre. The read distance must be: 9 to 11 mm. ...

2026 | www.dudiavel.com |