Ducati Diavel Service Manual: Replacing the front phonic wheel sensor
Disconnect the front abs sensor (2) connector (a) from the main electric wiring.
Open all the retainer clamps of the front abs sensor cable (2): refer to table of sect. 7 - 6, Flexible wiring/hoses positioning.
Loosen retaining screw (1) and remove the front abs sensor (2) with calibrated gasket (3).
Undo the screws (20), remove the guide (19) and slide out the front abs sensor cable (2).
Before refitting, make sure that the contact parts between the front abs sensor (2) and its seat are not damaged and are perfectly clean.
Fit the new front abs sensor (2) in the relevant seat.
Insert the front abs sensor cable (2) in the guide (19) and fix it on the lh fork leg by starting the screws (20).
Tighten the screws (20).
Refit the front wheel as indicated in sect. 7 - 1, Refitting the front wheel.
Connect the connector (a) to the main wiring.
Restore all the retainer clamps of the front abs sensor cable (2): refer to table of sect. 7 - 6, Flexible wiring/hoses positioning.
Check the air gap between the front abs sensor (2) and the front phonic wheel (b) as indicated in sect. 7 - 7, Adjusting of the air-gap phonic wheel sensor.
Tighten the screw (1) to the torque of 10 nm +/- 10% (sect. 3 - 3, Frame torque settings).
System components
Screw
Abs front speed sensor
Sealing washer
Hose grommet
Abs rear speed sensor
Abs control unit
Front pump - control unit pipe
Control unit - front callipers pipe
Rear pump - co ...
Replacing the rear phonic wheel sensor
Disconnect the rear abs sensor (5) connector (c) from the main electric
wiring.
Open all the retainer clamps of the rear abs sensor cable (5): refer to table of
sect. 7 - 6, Flexible wiring ...
Other materials:
Protective apparel
Always wear a helmet. Most motorcycle accident fatalities
are due to head injuries.
For safety eye protection, gloves, and high top, sturdy boots
should also be worn.
The exhaust system becomes very hot during operation,
never touch the exhaust system. Wear clothing that fully
covers your ...
Removal of the cylinder heads
Using the tool code 88713.2676, Undo the nuts (21) on the cylinder head stud
bolts.
Remove the cylinder head nuts (21) and special washers (22).
Remove the cylinder head assembly by lifting it off the engine studs.
Repeat the same procedure for the other cylinder head. ...
Refitting the fuel tank
If the fuel tank has been disassembled into its component parts, reposition
all the parts as shown in the exploded view.
In particular:
tighten the screws (13) to a torque of 5 nm +/-10% (sect. 3 - 3, Frame torque
settings).
Refit the tank by inserting its rear side into the pin on the ...