If you believe that your vehicle has a defect which could cause a crash or could cause injury or death, you should immediately inform the national highway traffic safety administration (nhtsa) in addition to notifying ducati north america. If nhtsa receives similar complaints, it may open an investigation, and if it finds that a safety defect exists in a group of vehicles, it may order a recall and remedy campaign.
However, nhtsa cannot become involved in individual problems between you, your dealer, or ducati north america. To contact nhtsa, you may either call the auto safety hotline toll-free at 1-800-424-9393 (or 366-0123 in washington, d.C. Area) or write to: nhtsa, 1200 new jersey avenue se w43-488, washington, d.C. 20590. You can also obtain other information about motor vehicle safety from the hotline.
Safety warnings
Traffic rules vary from jurisdiction to jurisdiction. Know the regulations in your jurisdiction before riding this motorcycle.
Warning
This motorcycle is designed and intended for use on streets and other smooth, paved areas only. Do not use this motorcycle on unpaved surfaces. Such use could lead to upset or other accident.
Noise emission warranty
Ducati motor s.P.A. Warrants that this exhaust system, at the time of sale, meets all applicable u.S. Epa federal noise standards. This warranty extends to the first person who buys this exhaust system for purposes other than resale, and to all subsequent buyers. Warranty claims should be directed to: ducati north america, 10443 bandley drive, cupertino, california, 95014 tel: 001.408.253.0499 - Fax: 001.408.253.4099.
Noise and exhaust emission control
system informationRemoval of the starter motor idler gear
Slide the gear pin (21) complete with the gear (19) and washer (20).
Warning
Pay attention to the washer (20) since it may fall inside the
crankcase half.
At this point, it is possible to remove the starter motor as described in
sect. 6 - 3, Starter motor. ...
Removal of the cylinder heads
Using the tool code 88713.2676, Undo the nuts (21) on the cylinder head stud
bolts.
Remove the cylinder head nuts (21) and special washers (22).
Remove the cylinder head assembly by lifting it off the engine studs.
Repeat the same procedure for the other cylinder head. ...
Instrument panel on tank
Menu 1 (tot, trip1, trip2, trip fuel).
Menu 2 (cons.Avg., Cons., Speed avg, air and
trip time) if active.
Gear / neutral indication.
Icon referred to the function below from menu 1.
Indication of engine setting for the currently set riding
style.
Currently set riding style (riding m ...