Ducati Diavel
Free Service and Repair manuals

Ducati Diavel Service Manual: Residual range indication when the service is due

Ducati Diavel Service Manual / Electric system and engine control system / Instruments / Residual range indication when the service is due

After resetting the first oil service warning (triggered at 1000 km), upon every key-on the system displays the indication of which type of service should be performed next (oil service or desmo service) and the residual range.

A (green) warning (1) is activated for 2 seconds on every key-on; while 1000 km before the threshold an (amber yellow) warning (2) is activated for 5 seconds upon every key-on.

Residual range indication when the service is due


First warning - oil service 1000 km
The first warning is activated at 1000 km (600 miles) of odometer reading. The (red) warning is activated as a large icon for 10 seconds upon every key-on (1) then as a small warning that remain ...

Indication of range reached for service
When service coupon threshold is achieved, upon every key-on the system displays the indication of the type of intervention that is required (oil service or desmo service). The (red) warning is ...

Other materials:

Pre-ride checks
Warning failure to carry out these checks before riding, may lead to motorcycle damage and injury to rider and passenger. Before riding, perform a thorough check-up on your bike as follows: Fuel level in the tank Check the fuel level in the tank. Fill tank if needed (page 140). Engine oil le ...

Disassembly of the generator cover
Undo the three stator retaining screws (25) and the two retaining screws (9) of the two cable grommet bracket (10) from inside the generator cover. Remove the stator (2) and the cable grommet bracket (10). The generator-side crankcase cover is fitted with a bearing (27), held in pla ...

Indicator trip time - trip time
This function shows the vehicle trip time. The calculation is made considering the time travelled since the last trip 1 reset. When trip 1 is reset, the value is set to zero. The active phase calculation occurs when the engine is running and the vehicle is stopped (when the vehicle is not ...

2022 | www.dudiavel.com |