Ducati Diavel
Free Service and Repair manuals

Ducati Diavel Owners Manual: Residual range indication when the service is due

Ducati Diavel Owners Manual / Instrument panel (dashboard) / Residual range indication when the service is due

After resetting the first oil service warning (triggered at 1000 km), upon every key-on the system displays the indication of which type of service should be performed next (oil service or desmo service) and the residual range.

A (green) warning (1, fig. 32) Is activated for 2 seconds on every key-on; while 1000 km before the threshold an (amber yellow) warning (2, fig. 32) Is activated for 5 seconds upon every key-on.

Warning


This message can only be reset by the ducati dealer or authorised service centre that performs the maintenance.

Residual range indication when the service is due


Maintenance indicator
This function indicates that the vehicle is about to or has travelled a distance for which an authorised ducati service centre should be contacted to have the general maintenance or oil change perf ...

Indication of range reached for service
When service coupon threshold is achieved, upon every key- on the system displays the indication of the type of intervention that is required (oil service or desmo service). The (red) warning is ...

Other materials:

Removal of the front brake master cylinder
Warning The brake master cylinder manufacturer advises against servicing the brake master cylinder due to the safety critical nature of this component. Incorrect overhaul of these critical safety components can endanger rider and passenger safety. Maintenance operations on these units are l ...

Lap activation/deactivation function (lap time)
This function activates and deactivates the lap function (lap time). To access the function it is necessary to view the "setting" menu page 48, using button (1, fig. 14) ?" " or (2, fig. 14) ?" " select the "lap" function and press the reset button ...

Refitting the rear brake control
If the pushrod (18), clip (30) and fork (31) assembly has been dismantled, reassemble it by screwing the nut (29) onto the rod (18) and then screw the rod into the fork (31) to obtain the measurement indicated in the figure. Block the rod and tighten to a torque of 7.5 Nm +/- 10% (sect. 3 - ...

2026 | www.dudiavel.com |