Ducati Diavel Service Manual: Seat

Refitting the fuel tank fairings

Make sure that the following components are fitted on the tank fairing (22): Spacers (18); Seals (20). Fit the clips (19) to the central cover (22) at the positions shown, inserting the tab ...

Removal of the seat

Insert the key in the lock, turn it clockwise and release the seat. Pull the seat (1) backwards to release it from the front catches and remove it. ...

Other materials:

Adjusting the rear shock absorber
The rear shock absorber has external commands that enable you to adjust the setting to suit the load on the motorcycle. The adjuster (1, fig. 111) Located on the lower connection holding the shock absorber to the swingarm adjusts the damping during the rebound phase (return). The knob (2, f ...

Checking protection and safety device components
Checking the side stand switch Remove the switch (1) from the side stand undoing screw (2) and disconnect the main wiring connector from the switch (see paragraph "routing of wiring on frame", sect. 6 - 1). Use an analogue or digital multimeter (sect. 6 - 11, Using a multimeter to check the ...

Replacing the high and low beam bulbs
Before replacing a burnt-out bulb, make sure that the new bulb complies with the voltage and wattage specified in the "wiring diagram", page 179. Always test the new bulb before refitting any parts you have removed. Fig. 150 Shows the locations of the low beam bulbs (lo), high beam ...