Ducati Diavel Service Manual: Service tools

Engine torque settings

*Dynamic safety-critical point; tightening torque must be within nm +/-5%. Note For product specifications and symbols, refer to paragraph "product specifications" (sect. 1 - 2). ...

Specific tools for the engine

88713.2011.Tool to lock crankshaft at top dead centre 88713.2676 .Wrench for tightening cylinder head nuts 88713.2103 Stand for cylinder head assembly 88765.1657 Timing check tool ...

Other materials:

Reassembly of rear shock absorber - rocker arm - linkage assembly
Once the needle roller bearings (9) have been removed from the rocker arm (18), upon reassembly fit a new needle roller bearing (9) on drift part no. 88713.1071 And lubricate with recommended grease. Support the rocker arm and drive the needle roller bearings into the rocker arm bore until t ...

Air temperature sensor
Introduction The engine control system on the diavel uses a sensor that measures air temperature. This sensor has a resistance of ntc type (negative temperature coefficient), that reduces its own value when the temperature increases. The air temperature sensor allows the engine control unit t ...

Inputs and outputs of engine control unit and connection to can network
The diagram illustrates the inputs and outputs for the engine control unit. The signals from the brake buttons, the exhaust by-pass valve command signal and the gear sensor signal are transmitted over the can line. 1I emergency engine cutout switch 2I start button 4I side stand button 6 ...