Ducati Diavel Service Manual: Start procedure with pin code (no keys)
The motorcycle may be started without keys with a special procedure using the dashboard and the switches on the handlebar.
Note
This procedure is only possible if the pin code has been enabled previously. For security reasons, the pin code is disabled by default when the vehicle leaves the factory.
To switch on the dashboards without having the key and start the procedure with the pin code (provided that the pin code is active) it is necessary to press once the on/off button on the hands free system.
Once vehicle speed exceeds 5 km/h after starting the motorcycle with the pin code, the no key message is displayed on the dashboard. This is normal.
After switching both the engine and the dashboards off, the pin code entry procedure has to be repeated in order to use the motorcycle again.
How to enable engine start with pin code
See the paragraph relevant to the dashboard for entering and using the pin codeimmobilizer override procedure in sect.
6 - 7.
How to enable the pin code
See the paragraph relevant to the dashboard for enabling the pin codeimmobilizer override procedure in sect. 6 - 7.
Recovery procedure in the event of hands free system fault
If the hands free system can no longer communicate with the other control
units over the can network (with the
dashboard or engine on), the following icon is shown on the tank dashboard:
The fol ...
How to reset the pin code
The pin code can be reset with the dds, i.E. It can be brought to the same
condition it was in when the bike came out
the factory. It is possible to complete the procedure with the relevant pin cod ...
Other materials:
Changing the engine oil and filter cartridge
Note
This operation has to be carried out with hot engine (but turned off)
because the oil in these conditions is more fluid and
its evacuation is faster and complete.
Remove the drain plug (3) with seal (a) from the oil sump and allow the oil
to drain off.
Warning
Dispose of oil and/or fil ...
Removal of belly fairing
Loosen and remove the screws (5) and (8) that secure the oil cooler (7) to
the rh (1) and lh (2) belly fairings.
Remove the lh belly fairing (2) by loosening the screws (3) with relevant
washers (4) and the screws (12).
Follow the same procedure to remove the rh belly fairi ...
Spark plugs replacement
Check the colour of the ceramic insulation around the central electrode:
an even, light brown colour indicates the engine is in good condition and
running at the right temperature.
Inspect the centre electrode for wear and check spark plug gap, which should be:
0.8+/-0.1 Mm.
Important
...