Ducati Diavel Service Manual: The hands free system
- Introduction to the "hands free" system
- Operating principle
- How to switch the dashboard on
- How to start the engine
- How to start the motorcycle if the active key is not working
- How to start the motorcycle without keys
- How to turn the motorcycle off
- Recovery procedure with no key
- Recovery in the event of flat active key battery
- Recovery procedure in the event of electric steering lock fault
- Recovery procedure in the event of hands free system fault
- Start procedure with pin code (no keys)
- How to reset the pin code
- Wiring diagram of the hands free system
- The hands free module
- Communication antenna
- On/off switch on handlebar
- The hands free relay
- Active key
- Passive key
- Programming/reprogramming keys
Pin code change function
This function changes your four number pin code.
To access the function it is necessary to view the "setting"menu, using buttons
(1) "s" or (2) "t" to select the "pin code"
function and press th ...
Introduction to the "hands free" system
The hands free system allows the rider to start the engine without physically
using the ignition key. The ignition key
merely has to be in the vicinity of the motorcycle, such as in the rider's
p ...
Other materials:
First warning - oil service 1000 km
The first warning is activated at 1000 km (600 miles) of odometer reading.
The (red) warning is activated as a large icon for 10 seconds upon every key-on
(1) then as a small warning that
remains displayed (2) until it is reset.
...
Air temperature sensor
Introduction
The engine control system on the diavel uses a sensor that measures air
temperature. This sensor has a resistance of
ntc type (negative temperature coefficient), that reduces its own value when the
temperature increases. The air
temperature sensor allows the engine control unit t ...
Removal of the primary drive gear
Withdraw the clutch housing (1) complete with driven gear of the primary pair
(a).
Remove the inner spacer (2).
Remove the oil pump (d) (sect. 9 - 2.1, Removal of the oil pump).
Lock the primary pinion (b) with the holding tool 88713.3417 And loosen the
threaded ring nut (3) u ...