Ducati Diavel Service Manual: Timing system
- Central external cover
- Air filter
- Horizontal cylinder timing belt cover
- Screw
- Filter support
- Screw
- Washer
- Nut
- Tensioner pulley assembly
- Circlip
- Camshaft pulley
- Tensioner pin
- Idler pulley assembly
- Timing belt
- Nut
- Key
- Spacer
- Camshaft pulley
- Driveshaft pulley spacer
- Spacer
- Nut
- Screw
- Washe
- Spacer flange
- Vertical cylinder belt external cover
- Central protection
- Screw
- Mesh
Spare parts catalogue
Diavel abs Timing system
Diavel abs cylinder head: timing system
Diavel carbon abs timing system
Diavel carbon abs cylinder head: timing system
Important
bold reference numbers in this section identify parts not shown in the figures alongside the text, but which can be found in the exploded view diagram.
Note
For clarity, the figures show the engine removed from the frame.
To work with the engine installed, first proceed as follows:
Note
Remove also any parts which may impede the procedure in any way.
- Removal of the timing belt covers
- Removal of the movable tensioner/timing belt
- Removing of the cylinder head pulley/fixed tensioner
- Disassembly of the camshaft pulleys
- Removing the timing belt driveshaft pulleys
- Refitting the timing belt driveshaft pulleys
- Refitting the idler and tensioner pulley mounting studs
- Reassembly of the timing pulleys
- Refitting the cylinder heads pulleys/fixed tensioners
- Refitting the timing belts
- Refitting the timing covers
Checking the engine timing
Set the engine to the configuration described for the "checking and adjusting
the valve clearances", previously indicated.
Install tool 88765.1188 (G) in the spark plug bore to determine the ...
Removal of the timing belt covers
Loosen the screws (4) securing the central external cover (1) and remove it
from the central side.
Undo the fixing screws (4) of the external cover (25) and remove it from the
vertical therma ...
Other materials:
Refitting the cylinder head assemblies
Warning
To prevent oil leaks past the contact area between cylinders and
crankcase, each time the head is removed, cylinder and
piston must be removed as well to clean the mating faces of crankcase and
cylinder and restore the spoiled gaskets and
o-rings and apply again liquid sealant (sect. ...
Refitting the oil pump
If removed, apply specific threadlocker on the bushing (7) outer thread, and
screw it in the crankcase half, observing the
height.
Position the reference bushings (15) and the oil sealing o-rings (2) and (4)
according to the crankcase lubrication
channels.
Position the oil pump on th ...
Rear-view mirrors
Rear-view mirror
Screw
U-bolt
Spring washer
Spare parts catalogue
Diavel abs handlebar and controls
Diavel carbon
abs
handlebar and controls
Important
Bold reference numbers in this section identify parts not shown in the
figures alongside the text, but which can be found in
...