Wet clutch controlled by the lever on left-hand side of the handlebar.
Transmission from engine to gearbox primary shaft via spur gears.
Front chain sprocket/clutch gearwheel ratio: 33/61 6-speed gearbox with constant mesh gears, gear change pedal on left side of motorcycle.
Gearbox output sprocket/rear chain sprocket ratio: 15/43
Total gear ratios:
1St gear 15/37
2Nd gear 17/30
3Rd gear 20/27
4Th gear 22/24
5Th gear 24/23
6Th gear 25/22
Drive chain from gearbox to rear wheel: make: did
Type: hv2 525
Dimensions: 5/8"x1/16"
Links: 118
Important
The above gear ratios are approved and should not be modified under any circumstances.
However, if you wish to tune up your motorcycle for competitions or special tracks, ducati motor holding s.P.A.
Will be pleased to provide information about the special ratios available. Please contact a ducati dealer or authorised service centre.
Warning
If the rear sprocket needs replacing, contact a ducati dealer or authorised service centre. Incorrect replacement of this component could seriously compromise your safety and cause irreparable damage to the motorcycle.
Frame
Als450 steel tubular trellis frame.
Aluminium cast rear subframe.
Steering head angle: 28.
Steering angle: 34 on the left / 34 on the right.
Trail: 130 mm
Wheels
Fourteen-spoke, light-alloy rims.
Front
Dimensions: mt 3.50X17".
Rear
Dimensions: mt 8.00X17".
Tyres
Front
Radial tubeless tyre.
Dimensions: 120/70-zr17
Rear
Radial tubeless tyre.
Dimensions: 240/45-zr17
Removal of the intake manifold and coolant union
Loosen the clips (f) and remove the hoses (t).
Remove the manifolds (25) undoing the screws (21).
Loosen the clamp (a) and remove the hose (b). Remove the union (12) and
recover the seal (24).
...
Changing the engine oil and filter cartridge
Note
This operation has to be carried out with hot engine (but turned off)
because the oil in these conditions is more fluid and
its evacuation is faster and complete.
Remove the drain plug (3) with seal (a) from the oil sump and allow the oil
to drain off.
Warning
Dispose of oil and/or fil ...
Refitting the camshafts
If the stud bolts (2) were removed, apply the recommended threadlocker to the
short end of the stud bolts (2), i.E. The
end that is to be screwed into the cylinder head. Tighten the stud bolts (2) to
a torque of 10 nm (min. 9 Nm - max. 11
Nm) (sect. 3 - 3, Engine torque settings).
Check t ...