Front tyre pressure: 2.50 Bar (rider only) - 2.6 Bar (with passenger and/or bags) rear tyre pressure: 2.50 Bar (rider only) - 2.6 Bar (with passenger and/or bags) as tyre pressures are affected by changes in temperature and altitude; check and adjust them whenever you are riding in areas where there are large variations in temperature or altitude.
Important
Check and adjust the pressures with the tyres cold.
To prevent distortion of the front wheel rim, increase tyre pressure by 0.2×0.3 Bar when riding on bumpy roads.
Tyre repair or change (tubeless tyres)
With minor punctures, tubeless tyres take a long time to deflate, as they tend to hold the air inside. If you find low pressure on one tyre, check the tyre for punctures.
Warning
Punctured tyres must be renewed.
Replace with tyres of the original brand and type.
Be sure to tighten the valve caps securely to avoid leaks when riding. Never fit tyres with inner tubes, as these can cause the tyre to burst suddenly, with possibly serious consequences for the rider and passenger.
After renewing a tyre, the wheel must be balanced.
Important
Do not remove or alter the position of the wheel balancing weights.
Note
Have the tyres replaced at a ducati dealer or authorised service centre. Correct removal and installation of the wheels is essential.
As some parts of the abs (such as sensors and phonic wheels) are mounted to the wheels and require specific adjustment.
Minimum tread depth
Measure tread depth (s, fig. 155) At the point where tread is most worn down.
It should not be less than 2 mm, and in any case not less than the legal limit.
Important
Visually inspect the tyres at regular intervals for cracks and cuts, especially on the side walls, and bulges or large stains that indicate internal damage. Replace them if badly damaged.
Remove any stones or other foreign bodies stuck in the tread.
Adjusting the front fork
The front fork used on this motorcycle has rebound, compression and spring
preload adjustment.
This adjustment is done using the outer adjusters:
Rebound damping;
Inner spring preload;
Compression damping.
Park the motorcycle in a stable position on its side stand.
Turn the adjust ...
Refitting the handlebar
Position the handlebar (4) so that the external lower corner of the marks (a)
on the handlebar matches the upper internal
corner of the lower u-bolts (b) as shown.
Apply the recommended grease to the threads and undersides of the heads of
the screws (3).
Important
Position the upper u-bo ...
How to start the engine
With the motorcycle off and the dashboard on, the on/off switch is turned to
"run off"
With the motorcycle and dashboard on, the on/off switch is turned to "run
off".
To start the engine, simply push the on/off switch up to "run on" and press the
black start button.
...