Ducati Diavel
Free Service and Repair manuals

Ducati Diavel Service Manual: Vehicle pre-delivery

  1. Transport packaging integrity check (if required);
  2. Removal from the transport packaging (if required);
  3. Motorcycle integrity check;
  4. Check of the supplied kit completeness (refer to the parts list supplied together with the bike packaging);
  5. Only if the bike is supplied in a crate: handlebar and controls assembly; check of controls operation, freedom of movements and any interference;
  6. Accessories assembly as of the customer order, and check of their operation (for instance electric tank plug, anti-theft system, gps, etc.);
  7. Battery start-up and fitting on the vehicle;
  8. Check of the tyres pressure:
  1. Brake and clutch fluid check (top-up if necessary);
  2. Engine oil level check (top-up if necessary);
  3. Check of the operation of lighting devices, turn indicators and horn; check of the adjustment of the headlight luminous beam height;
  4. Check of the operation of the active and passive key and the rh/lh steering lock;
  5. Throttle control operation check;
  6. Check of the front and rear wheel shaft tightening (front: 63 nm +/- 5% - rear: 230 nm +/- 10%);
  7. Check the brake calliper retaining screws tightening (front: 45 nm +/- 5% - rear: 25 nm +/- 5%);
  8. Fuel filling until the reserve warning light turns off (nearly 4 litres);
  9. Check of the operation of the kill switch and the side stand switch;
  10. Final and road test (abs trigger check and heated handgrips, if fitted);
  11. Vehicle cleaning;
  12. On-board documentation filling in (warranty card);
Maintenance operations
...

Scheduled maintenance chart
Operations to be carried out by the dealer List of operations to be performed at 1000 km Reading of the error memory with dds on the engine control units, vehicle and abs Change the engine oil C ...

Other materials:

Starter motor relay
Introduction When the rider presses the start button, with all the safety conditions required to enable engine start met, the engine control unit enables the relay that activates the starter motor. Component assembling position Connection on starter motor relay. Connection wiring diagram ...

Lap registration function
This function describes the "lap" time registration. If the function is activated (see "lap activation/deactivation description), the lap time can be registered as follows: Pressing the flash headlight button (11, fig. 12) The first time starts the "lap timer" for ...

Coolant expansion tank
Plug Screw Fuel filler flange Clip nut Clamp Hose clip Valve/tank hose Clamp Screw Spacer Rubber mounting Expansion reservoir Filler cap Hose clip Support Screw Washer Screw Hose clip Breather hose Clamp Pump/radiator sleeve Radiator/radiator sleeve ...

2025 | www.dudiavel.com |