Ducati Diavel Service Manual: Wiring diagram

Electric system and engine control system

...

Key to wiring diagram

Right-hand handlebar switch Immobilizer Hands free relay Hands free Front fuse box Right fan Left fan Fan relay Fuel pump relay Ride-by-wire relay (etv) Injection control unit ( ...

Other materials:

Replacing the tank flange and fuel sensor
Loosen the screws (19) securing the fuel tank flange (20). Remove the flange (20) from the tank (20). Recover the seal (21). Undo and remove the two fixing screws (g) and move the protection (f). Before reassembly, carefully remove any deposits or scale from all parts. Note The flang ...

Refitting the rear brake control
If the pushrod (18), clip (30) and fork (31) assembly has been dismantled, reassemble it by screwing the nut (29) onto the rod (18) and then screw the rod into the fork (31) to obtain the measurement indicated in the figure. Block the rod and tighten to a torque of 7.5 Nm +/- 10% (sect. 3 - ...

Checking the camshafts and supports
Check the cam contact surfaces for scratches, grooves, steps and waving. Worn cams are frequently the cause of poor timing, which leads to loss of engine power. Place the camshaft between two centres and check the run-out on the areas indicated using two dial gauges. Service limit: 0.1 ...