Ducati Diavel Service Manual: Key to wiring diagram
- Right-hand handlebar switch
- Immobilizer
- Hands free relay
- Hands free
- Front fuse box
- Right fan
- Left fan
- Fan relay
- Fuel pump relay
- Ride-by-wire relay (etv)
- Injection control unit (ems)
- Rear fuse box
- Data acquisition/diagnosis
- Starter motor
- Fused solenoid
- Battery
- Wiring ground
- Regulator
- Generator
- Fuel pump
- Fuel level
- Rear right turn indicator
- Rear light
- Rear left turn indicator
- Vehicle control unit (bbs)
- Antitheft alarm
- Exhaust valve starter motor
- Gear sensor
- Rear speed sensor
- Abs control unit
- Throttle twistgrip position sensor (aps)
- Starter motor - position sensor / ride-by-wire (tps/etv)
- Timing/rpm sensor
- Vertical map sensor
- Horizontal map sensor
- Engine temperature
- Air temperature sensor
- Vertical lambda sensor
- Horizontal lambda sensor
- Oil pressure switch
- Rear stop
- Side stand switch
- Clutch switch
- Front stop
- Main vertical injector
- Main horizontal injector
- Horizontal coil
- Vertical coil
- Left-hand handlebar switch
- Horn
- Front speed sensor
- Front left turn indicator
- Dashboard on handlebar
- Dashboard on tank
- Front right turn indicator
- Navigator
- High / low beam
- Parking light
Wiring diagram
Diavel abs wiring diagram
Diavel carbon abs wiring diagram
...
Wiring diagram colour codes
B blue
Bk black
Bn brown
G green
Gr grey
Lb light blue
O orange
P pink
R red
V violet
W white
Y yellow
Rear left fuse box (1) key
Rear right fuse box (2) key
...
Other materials:
Removal of the fuel tank fairings
Remove the rh air inlet (7) by loosening screws (6) and (9).
Undo the retaining screw (3) of the rh front half-fairing (1).
Slightly pull the pin (a) to disengage it from the seal (b), and remove the
rh front half-fairing (1) by sliding it onwards
and releasing the tabs (c) from the ...
Topping up the electrolyte
Warning
Before carrying out any operations on the battery, keep in mind the
safety standards (sect.1 - 3, General safety rules).
The electrolyte in the battery is toxic and can cause burns if it comes into
contact with the skin because it contains
sulphuric acid. Wear protective clothing, a ...
Noise and exhaust emission control
system information
Source of emissions
The combustion process produces carbon monoxide and
hydrocarbons. Control of hydrocarbons is very important
because under certain conditions, they react to form
photochemical smog when subjected to sunlight.
Carbon monoxide does not react in the same way, but is
toxic. Duca ...