Ducati Diavel Service Manual
п»ї
- General
- Information about the model
- Technical data
- Maintenance operations
- Fairings
- Electric system and engine control system
- Wiring diagram
- Battery charging system
- Electric starting system
- Lights and indicating devices
- Indicating devices
- Protection and safety devices
- Instruments
- The hands free system
- Introduction to the engine control system
- Introduction to the electrical system of the diavel
- Bbs and db faults
- Diagnostic instruments
- Chassis
- Front wheel
- Rear wheel
- Front brake control
- Rear brake
- Abs system information
- System components
- Abs components maintenance
- Handlebar unit
- Gearchange mechanism
- Fork
- Rear shock absorber assembly
- Swingarm
- Final drive
- Footrest brackets
- Stands
- Frame inspection
- Tail light - number plate holder
- Fuel/exhaust system
- Engine
General
...
Other materials:
Refitting the gearchange mechanism
Make sure that the gearchange linkage assembly (6) is installed with the ball
joint with a left-hand thread (a) facing the
lever (8).
Apply the recommended grease to the non-threaded surface of the pin (4).
Fit the first o-ring (5) in the pin (4).
Start the pin (4) in the gearchange leve ...
Appropriate diagnosis tools
97900.0211 Dds (ducati diagnosis system) without cables
97900.0227 Power cable and diagnosis
97900.0222 Power cable and diagnosis 1060838 (measurement module)
97900.0218 Vacuum sensor
552.1.039.1A Pressure sensor
97900.0220 Pressure/vacuum tube
97900.0221 Union
...
Key-on/key-off using the red key on the handlebar with the active key
A key-on can be performed by pressing the red key (6) on
the handlebar in the hands free on/off position and in
the presence of the active key (3, fig. 77).
Note
The active key (3, fig. 77) Has a range of approx. 1.5 M,
therefore it must be located within this range.
Key-off can be performed ...